![]() ![]() The heavy duty 11 gauge 3″ x 3″ uprights provide the ultimate support for max reps. See Supplemental Topics for Anchors or visit for more corrosion information.The Titan X-3 Flat Foot Power Rack is the ultimate solution for lifters and athletes looking for a top of the line Power Rack, without having to bolt the rack to the floor! Not for use in other corrosive or outdoor environments. Intended for some pressure-treated wood sill plate applications. Mechanical galvanizing meets ASTM B695, Class 65, Type 1. Titen HD® Anchor Product Data - Mechanically Galvanized using a torque wrench, driver drill or cordless 1/4" impact driver with a maximum permitted torque rating of 100 ft. * These models do not meet minimum embedment depth requirements for strength design and require maximum installation torque of 25 ft. Titen HD® Anchor Product Data - Zinc Plated Length of anchor is measured from underside of head to end of anchor. Models THD37134H and THD37212H do not meet minimum embedment depth requirements for strength design and require maximum installation torque of 25 ft. Larger holes are not required for wood or thinner cold-formed steel members. Suggested fixture hole sizes are for structural steel thicker than 12 gauge only. Tighten the anchor into the base material until the hex-washer head contacts the fixture.Insert the anchor through the fixture and into the hole.(Overhead installations need not be blown clean.) Alternatively, drill the hole deep enough to accommodate embedment depth and the dust from drilling and tapping. Drill the hole to the specified embedment depth plus minimum hole depth overdrill (see table below) to allow the thread tapping dust to settle, and blow it clean using compressed air. Drill a hole in the base material using a carbide drill bit the same diameter as the nominal diameter of the anchor to be installed. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |